Induction melting furnace water-cooled cable

Induction melting furnace water-cooled cable
 
The joint of the water-cooled cable is crimped to the copper strand by a cold press forming process. In this way, the connection is firm, the contact resistance is small, and the copper strand is not damaged. It can withstand more than 8t of tension between its single joint and copper wire. In order to reduce the loss of the water-cooled cable, the cable is in the form of a side lead. The water-cooled cable is taken from the side of the electric furnace to minimize its length. The connector of the water-cooled cable can be easily disassembled with a detachable structure. The inside is connected to the copper strand by soldering. In this way, the connection is firm and the contact resistance is small. The outer casing of the water-cooled cable is a rubber tube. This hose is not easy to burn and has good strength. It can withstand 0.45Mpa water pressure without leaking or breaking. The rubber tube will age after long-term use and will be replaced at this time. This detachable structure does not need to damage the internal copper strands, and it is only necessary to disassemble the bolts on the joints to facilitate the external replacement. The inside of the joints is sealed with a tapered surface and is electrically conductive. When the joint bolt is tightened, it naturally acts as both conductive and sealed.

intersting Products:*
Name:*
Company:
Email:*
Tel/Mobile:
Tell us your needs (as specific as possible)
-